Full service: Inspire works from the vision that you should be satisfied.

Post-printing
After a print has been produced, there can be some final processing what is summarized with the term Post-printing.

Cutting service
Your print basically is cut down to standard. For a smaller print with a large print run, a modest compensation is asked.

Coating service
Sunlight is the factor that is most responsible for wear and tear of your prints. In order
to extend the life of your prints with hundred percent, Inspire can provide these with a coating. Apart from the protection, the coating also gives a stylish glossy look to your prints and also protects them against moisture and dirt.

Mounting service
A beautiful print can lose its communicative power when it curls up or when
it will look untidy. That is a pity for your investment and certainly is not the
way in which you would like to communicate. In that case we advise you to
mount your print on a foundation. Inspire has several mounting materials.
Dependent on your wishes and the application, our professionals make a
choice regarding the most suitable mounting material. Sometimes it must
not be heavy. Sometimes it has to be heavy. In this way our mounting materials
vary with regard to the composition, rigidity, weight, topcoat, etc.

Saw service
When a print is mounted on a special foundation and the whole is sawn in
the form, we talk about a display. This can be prominently put down or hung.
A display has a proven sales-increasing effect. Inspire can make this happen.
Special saws and saw blades are used in order to give you a beautiful product
with a sharp cut.